DIY--Installation

1 Make posts to suspend rubber bands.

1-Incher

Insert terminals 1 black rubber band. 2 rubber bands. If tweeter bolts Insert Horn.

Turn bolts CCW to hold a base. make hard to place

a half rotation and the base, put rubber

insert terminals. feet under the base.

***************************************************************

Woofer Mi-Horn

Insert terminals 4 rubber bands. 1 big rubber band.

Turn screws CCW to hold a base.

a half rotation and

insert terminals.

***************************************************************

2 Make rubber posts to hold the base.

Get medium or large size adhesive rubber feet from Radioshack.

Cut one side of rubber feet as s picture.

Attach 3 or 4 adhesive feet around the base on the driver.

Only adhesive rubber feet hold a base.

***************************************************************

3 Using the speaker driver's magnet.

Make holes 3 thumbtacks inserted 4 thumbtacks Metal thumbtacks

with a hot needle. depend on # of make sure direct contact

tweeter bolts. thumbtacks don't with speaker screws

come off.

***************************************************************

4 Speaker bolts as rubber band suspension.

Remove speaker's bolts and insert a finish washer or a couple of washers (depend on size of bolts) to raise the bolt head. And put them back.

Connect each bolts (as picture) with thin wooden sticks or thead while the base of Mi-Horn is in the middle of that circle.

A rubber band holds a base. 2 rubber bands hold a base.

***************************************************************

5 Use washers or finish washers.

Washers & finish washer. 4" base is attached Insert a horn.

***************************************************************

6 Make small metal holders.

Coming soon....